QUICK START GUIDE Armona C O F F E E M A C H I N E S MACHINE DESCRIPTION LEGEND. PRODUCT CANISTER. PRODUCT CANISTER / CEE HOPPER. CEE HOPPER. CARD READER. DECAFFEINATED DOOR. DOSE BUTTON. SERVICE KEYPAD 8. DISPLAY 9. INFO BUTTON 0. SHIFT BUTTON. RUBBER PROTECTION. DOOR LOCK. STEAM WAND. ADJUSTABLE DELIVERY OUTLETS. DRIP TRAY. GROUNDS BIN HOW TO OPEN THE MACHINE DOOR A ) Pull down the coffee outlets completely. B) Turn the key and open the machne door.
STARTING UP DISPENSING After checkng that the machne door s closed and the ground bn and the drp tray are nserted, power on the machne by means of the man swtch underneath the machne basement (Fg.A). Push the servce keypad door to open t ( Fg.B) and press the (ON/) key to swtch ON the machne ( Fg.C). (FOR SELF CONFIGURATION, press the ( ON/ ) key before closng the machne front door. To swtch the machne, open the front door ). Power on the machne by means the man swtch underneath the machne basement. a Push the servce keypad door to open t. b CEE/CAPPUCCINO/CHOCO DISPENSING Adjust the coffee dspenser to the correct heght and place a cup under t then press the desred dose key. For Waters Card place the Smart Card above the proper reader before pressng the dose key. The Where ndcates the selected dose key name. The fllng up of the cup con ndcates the amount of drnk beng dspensed. Pressng the same dose key durng dspensng can stop the selected dose (not avalable for Self confguraton). In case of a mlk-based dose, press once to stop mlk dspensng, and once agan to stop coffee dspensng; the sequence depends on the type of dspensng. HOT WATER DISPENSING Adjust the hot water outlet to the correct heght and place a cup under t, then press the hot water key. Dspensng wll be automatcally stopped once the programmed dose s over. The HOT WATER Pressng the same dose key durng dspensng may stop the selected dose. WARNING: Hot water cannot be dspensed smultaneously wth steam. Press the (ON/) key to swtch ON the machne. c When the boler temperature of 0 C ( F) s reached, the machne carres out a group rnsng. The G.AUTO CLEANING When the set-up temperature s reached, the keypad lghts are on and the For machne confguraton Standard or Self: DECAFFEINATED DISPENSING (not avalable for Self confguraton) Adjust the coffee dspenser to the correct heght and place a cup under t, then open the decaffenated coffee door, the - Pour n the powdered coffee - Close the decaffenated door - Press the desred dose key. The The selected dose wll be dspensed wthout the actvaton of the grnders. If the decaffenated door s not closed, or f the dose button s not selected, the machne wll automatcally cancel ths functon after 0 seconds. The coffee group wll carry out a cleanng cycle of the brewng chamber. The EXTRAMILK DISPENSING (only LM machne, not avalable for Self confguraton) Press any mlk-based key and keep t pressed, after seconds foamed mlk wll start beng dspensed, the EXTRA MILK By releasng the pressed key, dspensng wll be stopped. STEAM WAND USE AND CLEANING Steam wand not avalable for machne n self confguraton. FILL IN BEAN HOPPER AND CANISTER Before usng the steam wand press the steam button to purge the nozzle. Use the steam wand to foam or heat any lqud nto the jug by handlng the rubber protecton. Press the steam button to stop the delvery before removng the jug. Fll n the requred amount for daly consumpton n order to keep coffee and product always fresh. After usng the steam wand press the steam button to purge the nozzle. Clean the steam wand by means of a cloth. DO NOT leave the steam wand nto any lqud at any tme. WE STRONGLY RECOMMEND TO USE AND CLEAN THE STEAM WAND AS ABOVE SHOWN
AUTOMATIC CLEANING OF CEE GROUP- MIXER AND MILK FROTHER At the end of each workng day, and/or n case the machne wll not be used some tme, we strongly recommend to carry out automatc cleanng of the coffee group,the mxer and the mlk frother. Keep (Shft) key pressed for fve seconds. group cleanng cycle. Open the machne door. Clean the group from any coffee resdues. Lft the coffee outlets completely. Remove and empty the grounds bn. 8 Remove and empty also the waste. (only for machnes wthout drect water dscharge) 9 Wat at least seconds, the dsplay wll show: Open front panel and clean component Open front panel and clean component Clean the group flters by means of a cloth. Close the front door. the detergent tablet nto the decaffenated door and close the cover. For machne n SELF confguraton open the front door and nsert the detergent tablet nto the brewng chamber, then close the door. Wat the end of the group cleanng cycle delvery. 8 Rensert the waste. Rensert the grounds bn and press ( ON/ ) key. A) Do not nterrupt the cleanng cycle. If the cleanng cycle s nterrupted by any type of operaton unrelated to the procedure, when the machne functonng s set back agan, the cleanng cycle wll automatcally be actvated. For cleanng operatons, carmal strongly recommend to use the followng detergent products: MILK FROTHER CLEANER CLEANING TABLETS cleanser B) Only n case that after the automatc cleanng process of the coffee outlet or the mlk frother are not properly dspensng, carry out a manual cleanng; see the followng steps. whsk cleanng cycle. 9 Wat the end of the Mxer cleanng cycle delvery. 0 mlker cleanng cycle. Take the mlk feedng tube out of the mlk box. MANUAL CLEANING OF MILK FROTHER AND CEE OUTLET WHISK CLEANING WHISK CLEANING Remove the coffee outlet from ts holder. Remove the mlk frother from the coffee outlet and dsconnect Slcone tubes No. -- and -. Dsassemble the mlk frother n all ts parts (frst by turnng and then by pullng as shown n the pcture) and wash t ether by hand or n a dshwasher. Make sure that all the holes are free from mlk resdues and also to use provded tools to clean the holes. Check also that the O-rngs are n good condton Dsassemble the coffee outlet () and wash t by hand or n a dshwasher. Make sure that all the holes are free from any coffee resdues, and also to use provded tools to clean the holes. Prepare a soluton of water and detergent (q.ty 00ml for standard verson, 00ml f mlk pump present) by followng the nstructons ndcated n the product label. the mlk feedng tube nto a contaner wth detergent. mlker cleanng cycle delvery. At the end of the mlker cleanng cycle the dsplay wll show: Repeat clean Usng only water - Put the mlk nfeed ppe nto a glass of cold water - Press (Shft) key, the mlk frother wll start dspensng another cleanng cycle only wth water. At the end of the mlker cleanng cycle wth only water the dsplay wll show :
MANUAL CLEANING OF MIXER MILK FROTHER ADJUSTMENT WE STRONGLY RECOMMEND CLEANING THE MIXERS ONCE A DAY Open the machne door Remove the ppe from the mxer Turn the flange antclockwse to remove the mxer Remove the mxer Foam settng The mlk frother s equpped wth a FOAM REGULATOR whch sets the quantty of ar needed to froth mlk. Turn the rng nut clockwse for thcker foam (small bubbles), or turn t antclockwse for more volumnous foam (large bubbles). Mlk temperature settng The mlk frother s equpped wth a MILK TEMPERATURE REGULATOR whch reduces the quantty of sucked mlk. Turn the regulator clockwse to ncrease the mlk temperature, or turn t antclockwse to reduce t. Rnse the Mxer n a snk Turn the flange clockwse to rensert the mxer Rensert the ppe from the mxer MACHINE FUNCTIONS MESSAGES OTHER RECOMMENDED CLEANING Alarm for machne door poston open door Cause: the front door s open; the mcro swtch does not touch the door machne functons CLOSE FRONT PANEL open door Close the door and turn the machne ON. Full grounds bn alarm a) Lft the coffee outlets After 0 seconds the dsplay completely. shows: Cause: ; the number of coffee grounds n the bn has reached the programmed value Press ( Info ) key, the dsplay coffeebased dspensng selectons shows: b) Remove and empty the CLOSE THE GROUNDS BIN grounds bn. EMPTY GROUNDS BIN WAIT 0 SEC. Rensert the grounds bn nto ts housng. DRIP TRAY CLEANING Once a day rnse the drp tray n a snk. GRINDERS ADJUSTMENT a) Turn the screw on the top of the machne antclockwse and then remove the hopper. GROUNDS BIN CLEANING Once a day rnse the grounds bn n a snk. b) Move the adjustment to the rght to get coarse coffee powder, to the left for fner. HOPPER CLEANING a) Turn the screw on the top of the machne antclockwse and then remove the hopper. b) Once a week clean the hopper by means of a cloth and approved food detergent. c) Rensert the hopper and lock t by turnng the screw clockwse. DISPENSER CLEANING a) Turn the screw on the top of the machne antclockwse and then remove the dspenser. b) Once a week clean the dspenser by means of a cloth and approved food detergent. Message of mssng coffee mssng coffee Cause: there s no coffee nto the hopper and therefore nto the brewng chamber Result: the machne nterrupts the coffee-based dspensng selectons FILL THE HOPPER mssng coffee Message of waste bn not n poston. The dsplay wll show the followng message: to reset the alarm put coffee nto the hopper and press agan the dose requred. INSERT WASTE CONTAINER waste out Message of mssng decaffenated mssng decaf. Cause: Mssng coffee n the decaffenated door and n the brewng chamber Result: The machne nterrupts the decaffenated dspensng selectons Soluton: press (Info) key, the Message of waste bn full. (ONLY FOR MACHINES WITHOUT DIRECT WATER DISCHARGE) The dsplay wll show the followng message: INSERT DECA CEE pownder /8 gr. mn. mssng decaf. To reset the alarm put decaffenated nto the decaf door and press agan the dose requred. EMPTY THE WASTE waste full waste out rensert the waste contaner. waste full remove the waste bn and empty t. BREW AND THROW TWO DOSES, THE THIRD ONE WILL BE DISPENSED WITH THE NEW GRINDER SET Cause: the waste bn s not n poston. The mcro swtch contact s open. dspensng keys. FOR ALL OTHER MESSAGES PLEASE REFER TO YOUR SERVICE CENTER. Cause: waste bn s full. The quantty of water nsde the waste bn touches the level probe. dspensng keys. Soluton : press ( Info ) key, the
ACCESS THE MAIN SETTING MENUS WITH PASSWORD OR SMART-CARD A) ACCESS THE MAIN SETTING MENUS WITH PASSWORD To enter the programmng envronments a password s requred, t defnes the access rghts to the dfferent envronments. The password must consst of dgts. To nsert the password proceed as follows: - Turn the machne - Keep the key pressed and at the same tme and turn the machne ON. The PASSWORD - - - - - one of the followng passwords by usng dgts from 0 to 8: - Water 0 0 0 0 0 - Owner After nsertng the password, the dsplay shows the man menu programmng envronments: INFO - RESET Press () key to show the followng parameters: - Read Doses Data DOSE PROGRAMMING Press () key to show the followng parameters: - Doses slght adjust - Set Dose Prce SYSTEM MANAGER Press () key to show the followng sub-menus: - Machne Parameter - System Clock Programmng - Servce - Smart Card Manager - Change Password - Alarm Hstory 8 SERVICE KEYPAD B) ACCESS THE MAIN SETTING MENUS WITH SMART CARD To enter the programmng envronments, place the Smart Card above the proper reader wth the machne n mode: - WAITER SMART CARD - OWNER SMART CARD Press the key, the dsplay shows the man menu programmng envronments as above descrbed. NT-0098-GB The Manufacturer reserves the rght to modfy the equpment presented n ths publcaton wthout notce. IMC S.p.A. Va Industrale, 00 Chgnolo d Isola (BG) Italy Tel. +9 0 900 Fax +9 0 90 www.carmal.com www.macco.t