GLASS TRAVEL TEA INFUSER User Guide Read and save these instructions SilverOnyx LLC 14807 S Heritagecrest Way, Ste B Bluffdale, Utah 84065 USA support@silveronyx.com www.silveronyx.com ver 0.2
PARTS & FEATURES A. Stainless Steel Lid w/ Silicone Seal: Removable twist-off lid with silicone seal and decorative mirror-finish cap. B. Stainless Steel Infuser: Fine-mesh, stainless steel filter attaches to base. C. Stainless Steel Base w/ Silicone Seal: Removable twist-off base with silicone seal and foam insert. D. Borosilicate Glass Bottle: Double-wall construction to keep contents hot or cold, while leaving outer glass warm or cool to the touch. ver 0.2 User Guide 2
USAGE INSTRUCTIONS NOTE: REFER TO CLEANING INSTRUCTIONS ON PAGE 4 BEFORE FIRST USE. 1. Remove base (with infuser) from bottle by twisting counter-clockwise. 2. Remove infuser/filter from base by twisting counter-clockwise. 3. Fill infuser with your favorite tea leaves, herbs, fruits, etc. 4. Secure infuser onto base, and then secure base with infuser onto bottle by twisting clockwise, until snug. 5. Remove lid from bottle by twisting counter-clockwise, then fill bottle with liquid up to, or below, the neck. 6. Secure lid onto bottle by twisting clockwise, until snug. 7. Gently turn the bottle side-to-side to help infuse ingredients with liquid. 8. Allow ingredients to infuse for desired amount of time, then remove base and infuser, discard contents and replace base. 9. Enjoy! WARNING: This bottle is made of temperature-resistant borosilicate glass, however pouring boiling water into a cold glass bottle, or vice-versa, may cause damage to the glass. ver 0.2 User Guide 3
CARE & CLEANING Cleaning Your Infuser Your tea infuser is made from materials that have different care and cleaning requirements. Before cleaning, be sure to separate the lid, base, and infuser from the bottle. Bottle For convenience, the glass bottle may be placed in the dishwasher on the top rack. To wash by hand, use a non-abrasive sponge, cloth, or bottle brush with dish soap. Infuser The mesh infuser may also be placed in the dishwasher on the top rack, or washed by hand. Lid & Base The lid and base must be hand-washed and should not be left to soak in standing water or any other liquid. NOTE: On occasion, you may wish to remove the silicone seals to clean them as well - to remove the seals, slide the handle of a spoon around the outside to lift them out. WARNING: It is important to allow time for all parts of the infuser to dry completely before using again - any water trapped on, or below, the seals may cause leakage during use. ver 0.2 User Guide 4
TROUBLESHOOTING Problem Possible Cause Suggested Correction Bottle is leaking There may be water on, or under, the silicone seal(s) Silicone seal(s) may be installed incorrectly Silicone seal(s) may be damaged Remove seal(s) from base and/or lid, dry completely and replace. Remove seals(s) from base and/or lid, flip over, and replace. NOTE: The flat/smooth side of the seals should be facing the glass. Remove seal(s) from base and/or lid and inspect for damage. Bits of tea leak into the water Bottle may be damaged Smaller bits of tea may slip through the fine mesh infuser Please contact us for replacement seals. Remove base and/or lid and inspect bottle edges for any damage. Larger loose leaf teas are recommended, however some fine tea particles may still fit through the infuser. ver 0.2 User Guide 5